The YETI XD Top Mount Draglink and Tie Rod Kit for drilled knuckles is a complete bolt-on for high steer applications and features our anti-flop linkage design. The YETI XD Top Mount is the quickest and easiest draglink flip on the market for drilled knuckles that have the drill knuckle bushing installed. Installation takes just minutes. Ball joint features, 30mm 1 1/2 Ton ball joints designed specifically for the JK, cold headed medium carbon alloy steel ball studs provide incredible impact toughness for extreme duty usage, induction heat treated ball studs provide ultimate fatigue strength and superior off-road durability, steel on steel bearings provide exceptional ball joint wear resistance and robustness, high quality seals ensure long ball joint life, superior seals have been rigorously tested to minimize leakage between grease service intervals which greatly improves our ball joint reliability over our competition, fully greaseable joints. Draglink end features; powder coat over E-coat for a long lasting appearance under harsh conditions, forged from medium carbon high harden-ability steel and heat treated for greater buckling, impact, and fatigue strength, large 1 1/4 inch rolled threads at tie rod adjuster and draglink ends provide significantly increased strength over the original equipment threads. Adjuster tube features; Draglink adjuster is manufactured from large diameter 1/4 inch thick wall high strength 4130 Chromoly steel tubing for maximum buckling strength, adjuster clamps assure proper clamp force using conventional tools without the possible risk of loosening like large jam nuts, designed with right hand and left hand threads for quick and easy adjustment when installed on the vehicle, Internal threads and tube are also e-coated for long term serviceability. This product is made in the USA. NOTE: KIT SHIPS IN 2 BOXES.