The Motobilt Crusher recessed winch bumper with grill hoop and stinger will provide you the ultimate in protection and recovery. The bumper allows you to secure your winch down low in between the frame rails. The grill hoop, stinger, and connecting tubes are made from 1.75-inch x .120-inch wall DOM tube. The high clearance design includes a built-in skid plate also. The bumper is made from 3/16-inch-thick steel plate that is laser cut at Motobilt HQ then cnc bent. The bumper uses 3/4-inch-thick laser cut d-ring mounts that pass through the bumper and are welded both inside and out. This setup provides for superior strength.

Features

Winch Ready
Measures in at just 46.5 inch at its widest point
3/16-inch-thick steel plate
3/4-inch-thick laser cut d-ring mounts that pass through the bumper and are welded both inside and out
Connecting tubes are made from 1.75-inch x .120-inch wall DOM tube
Includes all the necessary mounting hardware
Sold as kit

Note:

Will Not work with Teraflex S/T Dual rate front sway bar
The outer edge of the crash bar will need to be trimmed to fit where the lower portion of the bumper mounts
The 8 factory mounting holes may need to be open up to a 9/16".
Ships bare metal and will need to be painted or powder coated once you receive it
You must fully install BEFORE painting and then removed for paint or powder coating.
2012 and newer models will need a vacuum relocation pump. PN MB2060
Fairlead spacer included to allow use of a centered or off set winch design.
Does NOT work with Super Winch EXP